Yaskawa YASNAC PC NC Maintenance Manual Uživatelský manuál stáhnout pdf (Strana 98)

Chapter 4: Troubleshooting PC NC Maintenance Manual

4-77

The motor does not stop at the orientation.

Cause and measures

Cause Measures

Orientation signal OTR is not inputted. Check that orientation signal ORT is set to CLOSE by

the drive state display (U1-09).

Selection signal improper setting Confirm the selection signal setting and refer to the set-

ting list.

C1-39 bit 0:Encoder method, 1: Magnetic sensor

method

C2-22 bit 6:Load axis encoder, 1: Motor encoder

Encoder signal conductor disconnection /

improper connection / connector omission

[Encoder method]

Confirm that there is no abnormal motor speed changes

by the speedometer indication or the drive state display

(U1-01).

Exchange the encoder or the motor.

Magnetic sensor reading line disconnection /

improper connection /connector omission

[Magnetic sensor method]

Check the magnetic sensor signal conductor wiring.

Magnetic sensor and magneto fault

[Magnetic sensor method]

Confirm that ORG signal is to be lit once per every load

axis rotation by the drive state display function (U1-10).

Orientation card fault Exchange the orientation card with a non-defective one.

Control card fault Exchange unit (exchange control card)

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 300 301

Žádné komentáře

Yaskawa YASNAC PC NC Maintenance Manual Uživatelský manuál Strana 98